Journal Articles
Permanent URI for this collectionhttps://dspace.univ-soukahras.dz/handle/123456789/157
Browse
Item Analyse expérimentale et analytique du comportement en flexion des poutres en béton armé préfissurées renforcées par un matériau composite en toile de fibres de carbone (TFC)(Revue synthèse université Badji Mokhtar Annaba, 2012) Sihem Kermiche; Redjel BachirCe travail constitue une contribution à l’analyse du comportement des poutres renforcées par des matériaux composites. L’analyse a été faite par une étude expérimentale et analytique sur onze éléments en béton et en béton armé sous et moyennement armés, préfissurés puis renforcés par du tissu en fibre de carbone collé in situ à l’aide d’une résine époxy. Afin d’étudier l’influence de l’état de fissuration initiale sur le comportement, l’une des poutres a été renforcée sans qu’elle ne soit préfissurée et a été comparée à une poutre préfissurée et renforcée puis à une autre chargée jusqu’à la rupture sans être préfissurée ni renforcée. Dans cette étude quatre poutres ont été préfissurées et renforcées dans leur partie tendue et sur la partie latérale avec des bandes en forme de U de différentes dimensions dans le but d’éviter le décollement d’une part et d’étudier la reprise du composite à l’effet du cisaillement d’autre part. Enfin, une étude comparative a été menée entre les résistances ultimes mesurées expérimentalement et celles calculées par les modèles analytiquesItem Assessment of the Bacterial Pollution in the Distribution Network/Case Study of Souk Ahras Town, Algeria(2021-05-22) Mohamed Amine BENSOLTANE, Lotfi ZEGHADNIA, Abdelkrim GUEBAIL, Ahmed Salah ARAIBIA and Lakhdar DjemiliItem Assessment of the combined efects of Manning roughness and DEM resolution for the water surface elevation prediction using the HEC‑RAS model: a case study of Moudjar River in the Northeast of Algeria(2023-07-01) Said Kechida, Fares Laouacheria and Lotfi ZEGHADNIAItem Assessment of the combined efects of Manning roughness and DEM resolution for the water surface elevation prediction using the HEC‑RAS model: a case study of Moudjar River in the Northeast of Algeria(2023-07-01) Said Kechida · Fares Laouacheria · Lotf ZeghadniaKnowledge of variation of the water surface elevation in a river is very important for developing hydraulic models able to predict fooding and food hazard mapping. The roughness and DEMs resolution are factors that can afect the fow characteristics in a river. Manning's roughness plays a signifcant role because it is not a constant parameter and varies depending on the length of the river. DEM resolution is potentially the crucial element to give better food estimations. The objective of the present study is to assess the combined efects of Manning roughness and DEMs resolution to predict water surface elevation of the Moudjar River by using HEC-RAS 1D model. In this study, diferent results were obtained from various combinations of DEM resolution, and Manning roughness coefcients by applying the unsteady HEC-RAS (Hydrologic Engineering Centers- River Analysis System) 1D model on the Moudjar River in Algeria, to predict and quantify the performance regarding actual water surface elevation extent and the generated water surface limits. Data from February 02, 2019, to February 07, 2019, were used to determine predictive accuracy. The simulation results of the stage level of the river fow for diferent combinations of Manning’s roughness coefcient and DEM’s resolution show the closer values between the observed and simulated stage hydrograph, only in the case of the coarser DEM resolution (50 m) where the results are very distant and unacceptable. Statistical parameters such as Root Mean Square Error (RMSE), Mean Absolute Error (MAE), and Nash Sutclif (NSE) were used to verify the model's accuracy and predictive ability. The results obtained and the methodology applied to the Moudjar River can be used as a useful reference for HEC-RAS modelling and food predicting in Algerian rivers.Item Characterisation of the chemo‑mechanical behaviour of clays polluted by BTEX: a case study of benzene(2021-10-20) Hicham KAHLOUCHE, Abderrahim GHERIS and Mohamed GUENFOUDItem Comparative study of leachate treatment by coagulation-flocculation process using iron-based coagulants: A case study on Souk-Ahras city(2021-08-29) Saliha BOURANENE, Khaled Djeffal, Lotfi ZEGHADNIA and Abdalhak GheidItem Controlling water supply quality: case study of Souk Ahras City in Algeria(2020-08-10) Mohamed Amine BENSOLTANE, Lotfi ZEGHADNIA, Abdelkrim GUEBAIL, Ahmed Salah ARAIBIA, Fares LAOUACHERIA, Dounia MRAD and Lakhdar DJEMILIItem Determination of the microbiological characteristics and traces of heavy metals in rainwater harvested in urbanized areas to develop their uses: Case study of downtown Souk Ahras, Algeria(2023-01-30) Abdelkrim GUEBAIL, Sofiane BOUKHARI, Lotfi ZEGHADNIA, Ahmed Salah ARAIBIA and Saliha BOURANENEItem Determination of the microbiological characteristics and traces of heavy metals in rainwater harvested in urbanized areas to develop their uses: Case study of downtown Souk Ahras, Algeria(2023-01-30) Abdelkrim GUEBAIL, Sofiane BOUKHARI, Lotfi ZEGHADNIA, Ahmed Salah ARAIBIA and Saliha BOURANENEItem Discussion of “Direct Solutions for Uniform Flow Parameters of Wide Rectangular and Triangular Sections” by Ahmed A. Lamri, Said M. Easa, Mohamed T. Bouziane, Mohammad Bijankhan, and Yan-Cheng Han(2021-12-06) Lotfi ZEGHADNIA, Imad BOUKHARI, Ali REZAIGUIA and Fares LAOUACHERIAItem Discussion of “Direct Solutions for Uniform Flow Parameters of Wide Rectangular and Triangular Sections” by Ahmed A. Lamri, Said M. Easa, Mohamed T. Bouziane, Mohammad Bijankhan, and Yan-Cheng Han(2021-12-06) Lotfi ZEGHADNIA, Imad BOUKHARI, Ali REZAIGUIA and Fares LAOUACHERIAItem Évaluation de la sécheresse à l'aide d'indices météorologiques dans une zone semi-aride: cas de l’extrême Est de l’Algérie(2023-06-12) Amarchi Amina , Amarchi Hocine , Lotfi Zeghadnia and Fares LaouacheriaItem Explicit solutions for turbulent flow friction factor: A review, assessment and approaches classification(2019-03-05) Zeghadnia LotfiThe Colebrook –white equation is widely used in many fields, like civil engineering for calculation of water distribution systems and in all fields of engineering where fluid flow can be occurred. Numerous formulas have been proposed since 1947 in order to simplify the computation of the friction factor, to avoid the iterative procedures methods and to alter the Colebrook-white equation in practice. most of the existing explicit formulas for computation of the friction factor for turbulent flow in rough pipes proposed are cited, where thirty three ‘‘33” equations have been inventoried. The goal of this paper is to assess the accuracy of each model and to propose an arrangement from the best to the lower accuracy according to a proposed method combined of three criteria which are: simplicity of the formula, maximum deviations and the coverage of the entire range of Moody diagram. 2019 The Authors. Published by Elsevier B.V. on behalf of Faculty of Engineering, Ain Shams University. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-ncnd/4.0/).Item FEM investigation of concrete silos damaged and reinforced externally with CFRP(mechanics-industry, 2018) Sihem KermicheAbstract The present work investigates the reinforcement of concrete wheat-grain silos under initial damage. The reinforcement is achieved by mounting bands of carbon fiber reinforced polymer (CFRP) on the external walls of the silo. 4 modes of reinforcement are adapted according to the width of the band, the gap between two bands, the height of reinforcement and the number of layers achieved through banding. Analytical analyses were conducted using the Reimbert Method and the Eurocode 1 Part 4 method, as well as numerically through the finite element software Abaqus. Results show that the normal pressure reaches a peak value when approaching the silo hopper. Initial damage in a concrete silo was first determined using a 3D geometrical model, while the damage analyses were conducted to optimize the CFRP reinforcement by mounting 2 CFRP bands close together above and below the cylinder-hopper joint. Increasing the number of banding layers could produce better performance as the damage was slightly decreased from 0.161 to 0.152 for 1 and 4 layers respectivelyItem Kinetic Study of the Adsorption of Zinc and Copper Ions on to Activated Carbon Prepared from Date Pits(2021-10-08) Saliha BOURANENE, Nora Sedira, Lotfi ZEGHADNIA and Abdelkrim GUEBAILItem Study Of The Stability Of Water-In-Oil Emulsion Intended for the Extraction of Heavy Metals Application: Copper Ions(2021-08-03) Saliha BOURANENE, Ardjoune Amer Aouad, Abdeldjalil Gouassmia, Selma Djaber, Lotfi ZEGHADNIA and Abdelkrim GUEBAILItem التجمعات الصناعية العنقودية كاستراتيجية لدعم تنافسية االقتصاد الجزائري- دراسة قياسية للفترة الزمنية )2007 -2016- ) Clusterindustrial clusters as a strategy to support the competitiveness of the Algerian economy- Standardized study for the period of time (2007-2016) –(2022-12-28) بلايلية ربيع and بوفاس الشريف